OPERATION
1. Slide the power switch to Vacuum mode.
2. Using the easy glide wheels, position the MR-50 Steam - Vac over the
spill (wet or dry) until it has been removed and stored into the removable
dust collection reservoir.
3. When using on dry spills you can use the MR-50 Steam - Vac with or
without the Nylon brush. Use the nylon brush to aid in agitating the spill
area by inserting it into the mouth of the MR-50 Steam - Vac.
4. When using on wet spills ALWAYS use the smooth surface squeegee by
inserting it into the mouth of the MR-50 Steam - Vac. The squeegee is to be
used on all surfaces to remove wet spills.
WET - DRY VACUUM
DRY STEAM / WET STEAM
*Dry Steam mode produces a steam with less moisture and is used for
sanitizing and light stain removal.
*Wet Steam mode
produces a steam with heavy moisture and is used to
help saturate and soak the stained area to aid in removal.
1. Fill the water tank using the supplied measuring cup to the
MAX fill line. Using distilled or purified water will help prevent
scale and mineral deposits and extend the life of the machine.
(Never use any additives such as cleaners or perfumes in the
water tank).
2. Slide the power switch to Dry Steam or
Wet Steam mode.
3. After 20 seconds the MR-50 Steam - Vac
will produce ultra heated, sanitizing steam. (Steam will not start
immediately. Steam starts in approximately 20 seconds after the power
switch is set to a steam mode. This 20 second delay is to allow the
internal heating element to reach maximum temperature).
3
*Note: In most cases the power of steam will be able to eliminate the stain with the lowest possible
risk of damaging fabrics and carpets. Always use cleaning chemicals as a last resort and color test
in a concealed area first.
MAX
OFF
DRY STEAM
WET STEAM
VACUUM
OFF
DRY STEAM
WET STEAM
VACUUM
OFF
DRY STEAM
WET STEAM
VACUUM
STAIN REMOVAL
Follow these three steps for removing all spills and stains. EXTRACT...
STEAM... EXTRACT.
EXTRACT: Position the MR-50 Steam - Vac over the spill to remove as much
of the original spill as possible following the directions in the WET - DRY
VACUUM section above.
STEAM: Use the dry or wet steam mode along with the nylon brush to
saturate, sanitize and remove the stained area.
EXTRACT: Position the MR-50 Steam - Vac over the spill following the
directions in the WET - DRY VACUUM section above until it has been
removed and stored into the removable dust collection reservoir.
(12 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern